Installation Guide

Board Retainers

Gas Unit

Brick Boards

STEP 7 Return the ﬂ ame shield and then the gas unit by following steps two and three in reverse.

STEP 8 Replace Gas Unit. Check to ensure there are no gas leaks.

INSTALLATION OF OPTIONAL BRICK PANEL KIT

To install the Brick Panel Kit follow the instructions below:

STEP 1 Unhook gas line.

STEP 6

Insert board retainers

STEP 2

Remove gas unit by removing two screws one on

the left and right side of the burner.

STEP 3

Remove the ﬂ ame shield by taking out the four screws.

Keep this peace and hardware as it will be reinstalled.

STEP 4

Remove the insulations shield and insulation panel by taking out the four

screws. These items are no longer needed and may be discarded.

Warning:

Installation and service must be performed by

a qualified installer, service agency, or the gas

supplier.

Flame Shield

Insulation Shield

STEP 5

Insert brick board