Installation Guide

Flame Shield

#10A X 1/2 HX Screw

Flame Shield

Stainless Steel Insert

#10A X 1/2 HX Screws

Burner Unit

Stainless Steel Insert

STEP 1

Remove (4) four #10A X 1/2 HX screws and

ﬂ ame shield.

STEP 2

Remove the two bolts (one on the left and right

sides) that holds the burner unit in place. Remove

burner unit

STEP 3

Slide stainless steel insert into position.

Note: Do not remove refractory.

STEP 4

Slide ﬂ ame shield back into position and replace the

(4) four #10A X 1/2 HX screws that were previously

removed.

STEP 5

Replace burn unit back into position.

INSTALLATION OF OPTIONAL STAINLESS STEEL KIT

To install the Stainless Steel Kit follow the instructions below: