Installation Guide
24
SECTION VI
FREESTANDING INSTALLATION
1. Determine exact position of your gas heater.
NOTE: Due to high temperatures, this heater should be located out of traffi c areas and away from furniture
and draperies.
NOTE: For safe installation the minimum clearances must be met. See Figure below.
CAUTION: The installation must conform with local codes or in absence of local codes, with National Fuel
Gas Code, ANSI Z223.1/NFPA54.
NOTE: See “Gas Connection” section of this manual for Gas Connection and Pressure Check.
2. Make sure you have right valve for your type of gas. Check label on side of valve. Position logs as shown
in Log Placement Section. Position screen before leaving heater unattended.
This appliance is only for use with type of gas indicated on rating plate.
This appliance is not convertible for use with other gases.
WARNING: “YOUNG CHILDREN SHOULD BE CAREFULLY SUPERVISED WHEN THEY ARE IN SAME
ROOM WITH APPLIANCE.” “CHILDREN AND ADULTS SHOULD BE ALERTED TO HAZARDS OF HIGH
SURFACE TEMPERATURE AND SHOULD STAY AWAY TO AVOID BURNS OR CLOTHING IGNITION.”
WARNING: WHEN APPLIANCE IS INSTALLED DIRECTLY ON CARPETING, TILE OR OTHER
COMBUSTIBLE MATERIAL, OTHER THAN WOOD FLOORING, APPLIANCE SHALL BE INSTALLED
ON A METAL OR WOOD PANEL EXTENDING FULL WIDTH AND DEPTH OF APPLIANCE.
NOTE:
DIMENSIONS SHOWN ARE
MINIMUM CLEARANCE TO
COMBUSTIBLE WALL.
REAR WALL
STOVE
FACING UNIT
LEFT
WALL
RIGHT
WALL
7”
1-1/2”
CEILING
REAR WALL
SIDE VIEW
1-1/2”
24”
WALL
ST
OVE
WALL CORNER INSTALLATION
1-1/2”
1-1/2”