ProMark 700 ™ User Guide
Legal Notices Canada ©2013 Trimble Navigation Limited. All rights reserved. The digital apparatus does not exceed the Class B limits for radio noise emissions from digital apparatus as set out in the radio interference regulations of the Canadian Department of Communications. All product and brand names mentioned in this publication are trademarks of their respective holders. Limited Warranty Terms and Conditions Product Limited Warranty.
Table of Contents Welcome to Spectra Precision ProMark 700 ........................................1 ProMark 700 Packout .........................................................................2 Standard Accessories .............................................................2 Optional Accessories ..............................................................2 Using ProMark 700 for the First Time...................................................3 Discover Your New Equipment .............................
Congratulations on your decision to purchase a Spectra Precision ProMark 700. ProMark 700 is a GPS/GLONASS/SBAS L1/L2 receiver specifically designed to be used as a network RTK rover. ProMark 700 is very simple to use: • Easy battery handling: ProMark 700 uses built-in, rechargeable, non-removable batteries. • Cable-free: The data collector and the ProMark 700 communicate over a wireless connection. • GNSS-dedicated: ProMark 700 is focused on offering the best GNSS performance.
ProMark 700 Packout English Standard Accessories The ProMark 700 packout consists of the following items: [1] [2] [3] [5] [4] • [1]: ProMark 700 GNSS receiver • [2]: Universal AC/DC adapter shipped with four different types of input connectors. • [3]: Power cable extension (male jack to 6-pin connector) • [4]: Vehicle power cable (cigarette lighter connector type to female jack) • [5]: Soft transport bag. Optional Accessories Cable Kit P/N 91865-00 (see picture).
Discover Your New Equipment Take a few seconds to discover your ProMark 700. The power button, LED indicators, Power/Data connector and product labeling can be found on the bottom of the antenna. [6] [5] [4] [1] [2] [3] • • • • • • Charging the Batteries a b [1]: [2]: [3]: [4]: [5]: [6]: Power button (+fast charging control) Power/Charging LED Bluetooth LED (Wireless connection) 5/8” threaded insert 6-pin Power/Data connector with protective cap Shock absorber.
English 5. Wait a few hours until the batteries are fully charged. End of charging is denoted when the Power/Charging LED goes out. 6. Disconnect the AC/DC adapter from the ProMark 700. Put the cap back in place to protect the Power/Data connector during field operations. NOTE: The ProMark 700 may be left on the AC/DC adapter indefinitely without damage. Getting Started Reading the Battery Status 4 1. 2. 3. 4. Thread the ProMark 700 onto a range pole. Attach the data collector bracket to the pole.
The built-in batteries may be charged using one of two charging modes: • Standard charging: This is the default mode used when you connect a power source to the ProMark 700. The batteries will be fully charged after about 8 hours of charging. This is the recommended charging mode to preserve the capacity of the batteries over time. Typically, you will charge the batteries at the end of your work day so that you will have a fully charged system the next morning.
English The batteries will be charged typically while the ProMark 700 is off. However, charging is also possible with the ProMark 700 on. Watch the Power/Charging LED to read the current battery charging status (see table below).
Main Technical Specifications English Appendix GNSS reception: 220 GNSS channels: • GPS L1C/1, L2P and L2C • GLONASS L1 C/A and L2 C/A • SBAS: Code and carrier (WAAS/EGNOS/MSAS/GAGAN) Phase Center Diagram (NGS antenna name: SPP89823-10) L1 78.2 mm L2 62.2 mm Performance: • Real-time kinematic accuracy for baselines < 30 km (17 miles): – Horizontal: 10 mm (0.033 ft) + 1 ppm – Vertical: 20 mm (0.065 ft) + 1 ppm • Real-time performance: – Initialization time: < 10 seconds typical for baselines < 20 km (12.
English Environmental: • Storage temperature range: -40 to +70°C (-40 to +158°F) • Operating temperature range: -30 to +65°C (-22 to +149°F (1) • IP67 waterproof (according to IEC529 standard) • Vibrations and shocks: ETS300-019 • Withstands 2-meter fall on concrete.
Power/Data Connector Pinout Spectra Precision recommends you observe the following rules for long-term storage (2-3 months). These rules are dictated by the presence of two non-removable Li-Ion batteries inside the ProMark 700. • Always charge batteries before long-term storage • Storage room should be ideally at 5°C (41°F) ambient temperature to minimize irreversible capacity loss. • Always charge batteries after long-term storage.
Auto-test is performed during the receiver start-up sequence to check internal communication ports, including Bluetooth. Should a problem be detected during the auto-test, the Power/Charging LED will turn solid red -instead of the normal solid green- at the end of the start-up sequence. In that case, you should reset the receiver as explained in this manual (see above). If the error still persists after a reset, please contact Technical Support.
• • • • • • 11 English NOTE: If you are using the second setup, you will need to use the V-cable from the cable kit P/N 91865-00 which connects to your computer’s DB9 serial connector. In this case, you will not need to use the DB9-to-USB extension cable. Turn on ProMark 700 and wait until the Power/Charging LED turns solid green (meaning ProMark 700 is ready). Launch ProMark 700 Loader on the computer. Browse to the *.bin file provided by Spectra Precision.
Memo English • [1]: Power/Fast charging pushbutton. Hold this button depressed for about 2 seconds to power on the ProMark 700. Hold it depressed for another 2 seconds to turn it off. While the batteries are being charged in standard mode, a brief press on this button will cause the ProMark 700 to switch to fast charging mode.
A R Accuracy 7 Auto-tests 10 Range pole 4 Reset 9 B S Battery status 4 Bin file 10 Bluetooth LED 3, 4 C Cable extension (power) 2 Cable extension (USB to DB9-m) 2 Cable kit (option) 2 Certifications 8 Channels 7 Charging batteries 3 Charging modes 5 Charging times 8 Cigarette lighter 2, 5 Communication 7 D Data collector 4 DC power input 8 F Fast charging 5 Field software 4 Firmware upgrade 10 G GLONASS 1, 7 GPS 1, 7 GSM modem 4 L L1/L2 1, 7 LEDs during an upgrade (meaning) 11 M Memo 12 N N
ProMark™ 700 User Guide Contact Information: SPECTRA PRECISION DIVISION 10355 Westmoor Drive, Suite #100 Westminster, CO 80021, USA www.spectraprecision.com Rue Thomas Edison ZAC de la Fleuriaye, BP 60433 44474 Carquefou Cedex, FRANCE 80 Marine Parade Road #22-06, Parkway Parade Singapore 449269, Singapore ©2013 Trimble Navigation Limited. All rights reserved. Spectra Precision is a Division of Trimble Navigation Limited.
