Specifications

English
4
• Confirm installation by clicking Next> again. The wizard
starts copying the Spectra Precision Required Data files to
the receiver. At the end of this phase, a message window
appears asking you to check your mobile device screen to
see if additional steps are needed to complete the
installation.
• The receiver asks you to confirm the location where to
install Spectra Precision Required Data.CAB (“Device” is
the default choice). Choose “Device” (recommended).
•Tap Install at the bottom of the screen. The CAB file is
being installed.
• Go back to your computer and click OK to close the
message window and proceed. The installer on the
computer then runs the same sequence as the previous
one, this time to copy the MobileMapper Field installation
files to the receiver.
• Again, a message on the computer tells you to check the
receiver screen. Click OK then Close to complete the
installation on the computer side.
• As previously, the receiver asks you to choose the location
where to install the MobileMapper Field files. Choose the
same location as before for the Spectra Precision
Required Data.CAB file (i.e. “Device”), and then tap
Install.
Wait until the installation is complete. The receiver then
re-boots automatically. Once re-booted, the MobileMapper
Field option can be seen on the Home screen.
NOTE: Because MobileMapper 6 has only 89 Mb of internal
memory, use a different procedure to install MobileMapper
Field:
• Run the normal installation procedure, as described
above, but do not install Spectra Precision Required
Data.CAB when required to do so. Instead, skip this step
and simply install MobileMapper Field.
• Once installation is complete, copy Spectra Precision
Required Data.CAB from your computer (C:\Program
Files\Field Software\MobileMapper Field\) to an SD card.
• Insert the SD card in the receiver.
• Launch Required Data.CAB from the SD card and install
it in the internal memory.