Specifications

Command/Response Formats 193
Commands
Example: Set receiver as differential remote using port B
$PASHS,RTC,REM,B <enter>
SEQ: Check Sequence Number
$PASHS,RTC,SEQ,c
Checks sequence number of received messages and, if sequential, accept corrections;
if not, don’t use correction, where c is Y (check) or N (do not check). Default is N.
$PASHS,RTC,SEQ is used only in REMOTE mode. Valid only at beginning of
differential operation. After two sequential RTCM corrections have been received,
differential operation begins.
Example: Check sequence number
$PASHS,RTC,SEQ,Y <enter>
SPD: Base Bit Rate
$PASHS,RTC,SPD,d
Set the number of bits per second that are being generated to the serial port of the base
station, where d is the code for the output rate in bits per second. The available speeds
and corresponding codes are listed in Table 6.127 on page 193. Default is 300 bits per
second. $PASHS,RTC,SPD is used only in BASE mode.
Example: Set bit rate to 110 bits/sec
$PASHS,RTC,SPD,3 <enter>
Table 6.127: Available Bit Rate Codes
Code
012345678 9
Rate
25 50 100 110 150 200 250 300 1500 0 (burst mode)