Specifications

Command/Response Formats 195
Commands
TYP: Message Type
$PASHS,RTC,TYP,d1,d2
Enables the type of message to be sent by the base station and the period at which it
will be sent, where d1 is the type and d2 is the period. $PASHS,RTC,TYP is used
only in BASE mode. Table 6.129 on page 195 lists the message types available and
the period range setting. The default is type 1 set to 99, and type 6 is ON.
All messages can be enabled simultaneously with any output period setting, with the exception of
period 99; with simultaneous message, only one can be set at 99,
Example: Enable type 1, sent out every second
$PASHS,RTC,TYP,1,1 <enter>
Table 6.129: RTC,TYP Message Types
Type Range
01 0-99 seconds, where 0 is disabled and 99 is generated continuously
02 0-99 minutes, where 0 is disabled and 99 is generated continuously
03 0-99 minutes, where 0 is disabled and 99 is generated continuously
06 1 = ON, 0 = OFF (ON and OFF are also accepted)
16 same as type 3
18/19 Same as type 1
20/21 Same as type 1
22 Same as type 3