Installation Guide

Fig. 8
Fig. 9
Fig. 10
Step 4a: Nail Fin Door Installation (Go to Step 4b for No Nail Fin Installation)
A) Remove all packaging material (blocks, pads, protectors, stretch wrap, nail fin)
B) Inspect and verify the following:
a. The door unit is the correct size and configuration.
b. The unit is free from any damage or defects.
C) Contact your nearest Ashworth distributor if there are any problems with step B above.
D) Install the supplied nail fin to both sides and top of the door as shown below. The location of
the nail fin depends on the jamb depth of the rough opening. Ensure that the correct location
is chosen prior to applying the nail fin. (Fig. 8)
E) Apply the supplied nail fin corner gaskets.
F) Apply sealant to the outside face of the nail fin. Tool in sealant to ensure no voids. (Fig. 9)
G) Install upper nail fin corner gaskets. (Fig. 10)
a. Remove protective paper from back of nail fin corner gasket.
b. Place foam nailing fin gasket over corner with inside corner of the gasket tight against
outside frame corner.
c. Repeat application at all corners where the nail fins meet.