Specifications Sheet

AMERICAN SPECIALTIES, INC.
441 Saw Mill River Road, Yonkers, NY 10701
[phone] • [phone]
www.americanspecialties.com
THIS MANUFACTURER RESERVES THE RIGHT TO MAKE CHANGES IN DESIGN OR DIMENSIONS WITHOUT FORMAL NOTICE
EZFILL™ MULTI-FEED VANITY MOUNTED AUTOMATIC FOAM SOAP DISPENSER (PAGE 2 OF 2)
MODEL №: 0393-(n)
ISSUED: 6/2016
REVISED: 12 JUL 2016
INSTALLATION
Install spout and sensor housing to vanity deck with anti-rotation kit escutcheon flange, rubber washers and basin nut
(supplied) through 1-1/8" diameter [Ø28.5] mounting hole and 5/32" diameter [Ø4] adjacent hole for anti-rotation pin of
escutcheon flange. Connect short flex tubing from soap dispenser head to fitting on top of foam compressor. Connect com
plug from dispenser head to com socket from foam compressor. Mount pump assembly with wall bracket to convenient
structure under vanity within 24" [610] of L-fitting on foam compressor bottom with two (2) screws and wall anchors
(supplied). Connect long flex tubing from air compressor to fitting on top of pump assembly. Connect com plug from foam
compressor to com socket from pump assembly. Connect soap supply flex tubing (provided attached to fitting on pump
assembly) to one of six available connectors on Multi-Feed tank (model 0390, supplied separately) so that tube end is just
above bottom of tank. Mount battery compartment in convenient location under vanity deck with two (2) screws and wall
anchors (supplied) within easy reach of extension cable length and plug connector into mating inline power connector. Install
six (6) D size 1.5V cells (supplied by others) in under-deck battery compartment according to polarity indication, plug
extension cable jack into battery box socket in cover handle and screw lock cover. Alternatively, plug AC Adapter into GFCI
power outlet located under vanity within 13.5 ft (412 cm) of pump assembly and plug connector into mating inline power
connector.
OPERATION
System shall operate each time an object is positioned within the sensing range of 1-3/16" to 3-15/16" ± 3/8" [30 to 100 ±
10] directly in front of the spout of the dispenser. A stream of foam soap will be pumped from the nozzle during each
activation. Optional remote control unit Model № 0393-R (supplied {one (1) per six (6) pack} or order separately) will
allow owner programming of alternate dispense amounts and simplify priming when refilling Multi-Feed tank (not supplied,
order separately) for initial setup and soap-out conditions. See Model № 0393-R TDS and Owner’s Manual for complete
description of functions. Unit will dispense foam soap while batteries are at suitable charge level (or AC adapter is
connected) and correct viscosity soap is present in the tank and system is correctly maintained to enable dispensing (red LED
is not flashing continuously or does not remain dark when trigger attempt is made). LED will display red flash for sensing
and continuous flashing for low battery condition. Manual priming fill button releases soap for easy soap priming. System
shall allow filling soap from top of vanity without requiring removal of tank under vanity. Soap is manually replenished and
batteries are replaced on service interval determined by maintenance schedule. See OM & IG for complete description of
Features and Operations.
Schedule of Model № Suffix Codes and Application
Model № Suffix Service Application
1A Universal Model, Battery Operation
1AC USA/UK/EU Interchangeable Plug Model, AC Adapter Operation
3AC AU Model, AC Adapter Operation
6-1A Universal Model, Battery Operation, Six Pack
6-1AC USA/UK/EU Interchangeable Plug Model, AC Adapter Operation, Six Pack
6-3AC AU Model, AC Adapter Operation, Six Pack