Specifications Sheet

ISSUED:
REVISED:
MODEL No:
Accessory Specialties AMERICAN DISPENSER D esert R ay P roducts ,INC.
THIS MANUFACTURER RESERVES THE RIGHT TO MAKE CHANGES IN DESIGN OR DIMENSIONS WITHOUT FORMAL NOTICE
1-87
0473-A
9-04
SURFACE MOUNTED END STALL SANITARY NAPKIN DISPOSAL
AMERICAN SPECIALTIES, INC.
441 Saw Mill River Road, Yonkers, NY 10701 [phone]
SPECIFICATION
Surface Mounted End Stall Sanitary Napkin Disposal shall hold 1.5gal (5.7liters) of dry/solids waste and shall have door and cabinet
fabricated of alloy 18-8 stainless steel, type 304, 22 gauge; all exposed surfaces shall have N
o
4 satin finish and be protected during
shipment by a PVC film. Door shall be attached to cabinet with a full length 3/16" dia. (5mm) stainless steel multi-staked piano hinge
and shall be spring loaded to hold in closed position. Structural assembly of body and door components shall be of welded construction
and cabinet shall have no exposed fastening devices or visible spot welded seams. Removable waste container shall be captured
internally by full width Ζ- retainer and shall have a safety-edged finger grip.
Surface Mounted End Stall Sanitary Napkin Disposal shall be Model N
o
0473-A as manufactured by American Specialties,
Inc., 441 Saw Mill River Road, Yonkers, New York 10701-4913
INSTALLATION
Unit is mounted on wall using N
o
10 self-tapping screws (by others). Collar trim provides cabinet body profile even with front trim
bezel. For maximum usability and compliance with ADA Accessibility Guidelines, unit should be installed so that top of disposal
door is between 34" (864mm) maximum above finished floor (AFF) and 24" (610mm) minimum AFF.
OPERATION
User pushes door to deposit waste material. Door is self-closing. Maintenance schedule determines waste removal cycle. Unit is
emptied by removing bottom waste container and inverting over collection bag. Waste container is captured by internal angle to
prevent inadvertent dumping and safety-edged finger grip provides convenient grip for service.