Specifications Sheet

AMERICAN SPECIALTIES, INC.
441 Saw Mill River Road, Yonkers, NY 10701
[phone] • [phone]
www.americanspecialties.com
THIS MANUFACTURER RESERVES THE RIGHT TO MAKE CHANGES IN DESIGN OR DIMENSIONS WITHOUT FORMAL NOTICE
INTER-LOK STAINLESS STEEL FRAMED MIRROR
MODEL №: 0600
ISSUED: 01/87
REVISED: 19 FEB 2018
SPECIFICATION
Inter-Lok Stainless Steel Framed Mirror shall have frame fabricated of alloy 18-8 stainless steel, type 304, 18 gauge with mi-
tered corners welded and polished. All exposed surfaces shall be N
o
4 satin finish. Mirror glazing shall be _____(insert glazing
option) and shall be warranted for 15 years against silver spoilage. All edges of mirror shall be protected with friction and chafe
absorbing fillers. Back of mirror shall be protected by full size shock-absorbing water-resistant filler and full size one piece 20
gauge corrosion protected steel. An 18 gauge corrosion protected steel ‘H’ bracket shall be supplied. Mirror shall be secured to
vertical bracket with corrosion protected allen head locking screws furnished.
Inter-Lok Stainless Steel Framed Mirror shall be Model N
o
0600-___ (insert glazing option) _________(note size W x H)
as manufactured by American Specialties, Inc., 441 Saw Mill River Road, Yonkers, New York 10701-4913
MATERIALS
Frame: 18-8, type 304, 18gauge (.048 in. <1.2mm> thick) stainless steel. Unitized all welded construction. Corners mitered,
welded and polished. Exposed surfaces shall have a N
o
4 satin finish. Edges and corners are burr free.
Glass: Standard glazing is N
o
1 quality, 1/4" inch (6.4mm) thick plate/float, silver coated and hermetically sealed with a uni-
form coating of electrolytic copper plating, and warranted against silver spoilage for 15 years. Mirrors meet Federal
Spec DD-M-411C, ASTM C-1503, and ASTM C-1036-91.
Filler: Expanded polyethylene microcell foam sheet material, abrasion resistant and shock absorbing, water resistant, 1/8" inch
(3.2mm) total layer thickness.
INSTALLATION
Install bracket level and plumb as per diagram location using N
o
10 self tapping screws (by others). Hang mirror on bracket and
tighten locking screws at top & bottom. For compliance with 2010 ADA Accessibility Guidelines, bottom edge of reflecting
surface should be no higher than 40" (1016mm) above finished floor.
GLAZING OPTIONS
Units are supplied with 1/4” thick plate glass. Other glazing options are available. For a complete description, see the
MIRROR GLAZING OPTIONS chart.