Specifications Sheet

AMERICAN SPECIALTIES, INC.
441 Saw Mill River Road, Yonkers, NY 10701
[phone] • [phone]
www.americanspecialties.com
THIS MANUFACTURER RESERVES THE RIGHT TO MAKE CHANGES IN DESIGN OR DIMENSIONS WITHOUT FORMAL NOTICE
CHANNEL FRAME MIRROR
MODEL №: 0620
ISSUED: 01/87
REVISED: 19 FEB 2018
SPECIFICATION
Channel Frame Mirror shall have frame fabricated of alloy 18-8 stainless steel, type 304, 20 gauge with mitered corners. Mirror
glazing shall be _____(insert glazing option) and shall be warranted for 15 years against silver spoilage. All edges of mirror shall
be protected by friction and chafe absorbing fillers. Back of mirror shall be protected by full size shock-absorbing water-resistant
filler and full size one piece 20 gauge corrosion protected steel. Top and bottom wall mounting brackets shall be fabricated of 20
gauge corrosion protected steel and shall be spot welded into “H” hanger. Mirror shall be secured to lower bracket with a Phil-
lips Pan Head locking screw.
Channel Frame Mirror shall be Model N
o
0620-_____(insert glazing option)________________ (note size, W x H) as
manufactured by American Specialties, Inc., 441 Saw Mill River Road, Yonkers, New York 10701-4913
MATERIALS
Frame: 18-8, type 304, 20 gauge (.036" <.91mm> thick) stainless steel. Roll-formed one piece construction. Exposed surfac-
es have a N
o
4 satin finish. Edges and corners are burr free.
Glass: Standard glazing is N
o
1 quality, 1/4" (6.4mm) thick plate/float, silver coated and hermetically sealed with a uniform
copper plating, and warranted against silver spoilage for 15 years. Mirrors meet Federal Spec DD-M-411C, ASTM
C- 1503, and ASTM C-1036-91.
Filler: Expanded polyethylene microcell foam sheet material, abrasion resistant and shock absorbing, water resistant, 1/8
inch (3.2mm) total layer thickness.
FABRICATION NOTE FOR SPECIFICATION
Mirrors larger than 21sq. Ft. (1.95m
2
) are fabricated in two (2) or more sections to provide installation and handling ease.
INSTALLATION
Install “H” wall brackets level and plumb per diagram location using ONLY N
o
8 or N
o
10 Pan Head screws (by others). Hang
mirror on brackets and tighten locking screw (N
o
6-32F x 3/4" Philips Pan Head, supplied separately taped to mirror back) at
bottom (note: this screw should be started prior to hanging mirror on wall bracket). For compliance with 2010 ADA
Accessibility Standard, bottom edge of reflecting surface should be no higher than 40" (1016mm) above finished floor.
GLAZING OPTIONS
Units are supplied with 1/4" thick plate glass. Other glazing options are available. For a complete description of any other
available glazing, see the MIRROR GLAZING OPTIONS char t.