User's Manual

pressed.

- Press “Change” button for modifying the status, when the modification is

finished, press “Apply” to save it. The button “Change” and “Apply” is

alternately shown on the same position.

SSID :

The SSID (Service Set Identifier), also known as the Network Name, must be

unique to distinguish itself as a particular wireless network. All wireless

points in the network area share the same SSID. Type your network SSID in

the SSID field to associate with access points or stations within the specified

wireless LAN.

Channel :

This is the radio channel used by wireless devices within the network for

communication. This command is only available while you are operating in

the Ad hoc mode. Specify the operating radio frequency channel from the

pull-down menu if you are the creator of the wireless network. If you are

joining an existing network you do not need to select the channel; configure

the SSID and click Apply changes.

TX Rate :

Select the transmission rate by “ Tx Rate” drop down menu.

Network Type :

Select the “Ad_Hoc” or “Infrastructure” Mode by the “Network Type” drop

down menu.

Encryption :

Select the “Enable WEP” or “Disable WEP” by the “Encryption” drop

down menu.

Authentication Mode :

Select the “Open System” , “Shared Key” mode or “Auto” from the

“Authentication Mode” drop down menu.