User's Manual

MODAT-550A Mobile Data Collector
Page 10
To unpack the MODAT-550A, follow the steps below:
WARNING!
Only remove the protective plastic cover stuck to the front screen after
installation. The plastic layer protects the monitor surface during
installation process.
Step 1: Carefully cut the tape sealing the box. Only cut deep enough to break the tape.
Step 2: Open the box.
Step 3: Lift the MODAT-550A out of the box.
Step 4: Make sure all the components listed in the packing list are present.
Step 0:
2.1 Packing List
NOTE:
If any of the components listed in the checklist below are missing, do
not proceed with the installation. Contact the IEI reseller or vendor the
MODAT-550A was purchased from or contact an IEI sales
representative directly by sending an email to 3 [e-mail].
The MODAT-550A is shipped with the following components:
Quantity
Item
Image
1
MODAT-550A