User's Manual

41/64
Start PIN connection - SSID ~> Begin associating to WPS AP ~> Associated to WPS
AP ~> Sending EAPOL-Start ~> Sending EAP-Rsp (ID) ~> Receive EAP-Req (Start)
~> Sending M1 ~> Received M2 ~> (Received M2D ~> Sending EAP-Rsp (ACK))
~> Sending M3 ~> Received M4 ~> Sending M5 ~> Received M6 ~> Sending M7 ~>
Received M8 ~> Sending EAP-Rsp(Done) ~> Configured ~> WPS status is
disconnected ~> WPS status is connected successfully-SSID
z WPS configuration doesn't complete after a two-minute connection:
WPS EAP process failed.
z When errors occur within two minutes of connecting, the WPS status bar might
report "WPS EAP process failed".
Error messages might be:
1. Receive EAP with wrong NONCE.
2. Receive EAP without integrity.
3. Error PIN Code.
4. An inappropriate EAP-FAIL received.
2.7.3 Example to Add to Registrar Using PBC Method
The PBC method requires the user to press a PBC button on both the Enrollee and the
Registrar within a two-minute interval called the Walk Time. If there is only one
Registrar in PBC mode, the PBC mode selected is obtained from ID 0x0004, and is
found after a complete scan. The Enrollee can then immediately begin running the
Registration Protocol.
If the Enrollee discovers more than one Registrar in PBC mode, it MUST abort its
connection attempt at this scan and continue searching until the two-minute timeout.
*Before you press PBC on STA and candidate AP. Make sure all APs aren't PBC
mode or APs using PBC mode have left their Walk Time.
z Select an AP (SSID/BSSID) that STA will join to and Select the “Push-button
Configuration” method.