User's Manual

LM61 User Manual
7
 IPAddressEntertheIPaddressofyourrouter(factorydefault:
192.168.0.1). 
 SubnetMask‐Anaddresscodethatdeterminesthesizeofthenetwork.
Normallyuse255.255.255.0asthesubnetmask.
 DHCP‐EnableorDisabletheDHCPserver.IfyoudisabletheServer,Client
cannotgetvalidIPaddressfrommodelautomatically.Butyoucanconfigure
theaddressofyourPCmanuallytoconnectmodel
 StartIPAddress‐SpecifyanIPaddressfortheDHCPservertostartwith
whenassigningIPaddress.Thedefaultstartaddressis10.0.0.10.
 EndIPAddress‐SpecifyanIPaddressfortheDHCPServertoendwith
whenassigningIPaddress.Thedefaultendaddressis10.0.0.10. 
 LeaseTime‐TheLeaseTimeistheamountoftimeanetworkuserwillbe
allowedconnectiontotherouterwiththeircurrentdynamicIPaddress.
Entertheamountoftimeinminutesandtheuserwillbe"leased"this
dynamicIPaddress.Afterthetimeisup,theuserwillbeassignedanew
dynamicIPaddressautomatically.
 StaticIP‐IP/MACbindingfunction,thesystemwillassignafixedIPaddress
totheMACaccordingtotherules.
 Note: 
1. IfyouchangetheIPAddressofLAN,youmustusethenewIPaddresstologin
totheMODELrouter. 
2. IfthenewLANIPaddressyousetisnotinthesamesubnet,theIPaddress
pooloftheDHCPserverwillchangeatthesametime,whiletheVirtualServer
andDMZHostwillnottakeeffectuntiltheyarere‐configured.
3.4 Status
Onthispage,youcanseeWANStatus,LANStatus,4GStatusandSoftwareStatus.