Operation Manual
24
TO SET AND USE “3-CHANNEL ALARM”
ALARM MODE
● The alarm can be set to ring at three different times of a day. The time zone can also be selected from those set in the TIME Mode.
■ Alarm Time Setting
ALARM Mode
Alarm Setting Display
Press Button “E”
to select desired
alarm channel.
■ Selection of Alarm Channel
・ With each press of Button “E”, the alarm channel changes over in the following order.
・ The alarm sounds differently from channel to channel.
・ The alarm sound can be checked by pressing Button “D”.
■ Engagement/Disengagement of Alarm
・ With each press of Button”A”, the alarm is engaged and disengaged alternately. The
Alarm mark “ ” is shown when the alarm is engaged.
・ The alarm can be engaged or disengaged channel by channel.
・ The Alarm mark is shown if alarm is engaged in any one of the alarm channels.
■ To Stop Alarm
・ The alarm rings for 20 seconds at the designated time.
・ To stop the alarm, press any of the buttons.
[Alarm engaged]
* When the ALARM Mode appears, “ALARM” is shown in the upper row of the
display for 1 second, and then, the Alarm Display appears.
Button “B”:
Returning to ALARM Mode
Button “C”:
Turning on backlight
Button “C”:
[Press for more than 2 seconds]
Returning display to
TIME Mode
Button “B
”
:
[Press for more than 2 seconds]
Activation of Alarm Setting
Display
Button “E”:
・
Selection of alarm channel
・Selection of digits to be
adjusted
Button “A”:
・
Engaging/disengaging
alarm
・Increasing digits to be
adjusted
Alarm mark
Alarm channel
Indication for
alarm engagement/
disengagement
Button “D”:
・
Checking alarm sound
・Decreasing digits to be
adjusted
Press for
more than
2 seconds.
Hour
Minute
Time zone
(T1/T2)
[1] Press Button “E” in the ALARM Mode to select the desired alarm channel.
[2] Keep Button “B” pressed for more than 2 seconds to activate the Alarm Setting
Display. The minute digits of the alarm time start ashing.
[3] Press Button “A” or “D” to set the ashing digits.
* If Button “A” or “D” is kept pressed for more than 2 seconds, the digits move quickly.
[4] Press Button “E” to show the next digits to be adjusted (ashing).
[5] Repeat Steps [3] and [4] to set the digits in the order shown in the illustration at
right.
[6] After all the adjustments are completed, press Button “B” to return to the ALARM
Mode. The alarm is automatically engaged, and the Alarm mark “ ” is shown.
* If the watch is left untouched in the Alarm Setting Display with the digits ashing, the display
will automatically return to the ALARM Mode in 2 to 3 minutes.
* Please note that the alarm rings according to the current time of the time
zone you have selected (T1 or T2).
Alarm mark
[Alarm disengaged]
AH01-WJ30WJ31_英語版.ai 1 2013/02/24 21:35:28