Operation Manual
4
How to Connect the Sensor Unit with the Rubber Strap
Joint
Protrusion
PARTS OF YOUR HRM WATCH AND CHEST STRAP
WATCH
CHEST STRAP
Sensor unit (outer surface side)
Rubber strap
Outer surface side of
sensor unit
Rubber strap
Push in
1. 2. 3.
1. Insert the joint of the rubber strap into the hole of the sensor unit from its inner
surface side.
2. Turn the joint, and push in the protrusion at its tip until it clicks in position.
3. Check that the protrusion of the joint is invisible from the outer surface side of
the sensor unit.
* When wearing the chest strap around your chest, follow the same procedure to
connect the sensor unit and the rubber strap.
AH01-WJ30WJ31_英語版.ai 1 2013/02/24 21:29:15