Operation Manual

11
How to Use the Modes Available in Both SPM and PACE Functions
TIMER Mode
Button B: Returning
display to TIMER mode
Button B (pressed for more than 2
seconds): Showing TIMER SETTING mode
Button C: Lighting up backlight
Button D: Decreasing
digits to be adjusted
Button E: Selection of
digits to be adjusted
Button A: Increasing
digits to be adjusted
Instr uc tion Ma nua l
AP01 : WJ32
Start, Stop and Reset of the Timer
To start timer: Press button A to start the timer. The TIMER mark starts flashing.
While the timer is counting down:
To stop the timer during countdown, press button A again.
If 2 or more times is set for the number of repetitions, the timer repeats countdown the
number of times you have set.
The warning beep starts sounding 3 seconds before the set time is
up, and the time-up beep
sounds for 3 seconds after the set time is up.
To stop the time-up beep, press any of the buttons.
When the timer is stopped:
To reset the timer, press button E.
To restart the timer, press button A.
After the timer finished counting down the set time: It will be reset to the set time
automatically.s
When the TIMER mode appears, “TIMER” is shown in the lower row
of the di
splay for 1 second before the TIMER display is shown.
TIMER Setting

Keep button B pressed for more than 2 seconds. The seconds digits of the timer start flashing.
* Unless the timer is reset, the TIMER SETTING display will not appear. For the meth-
od of resetting the timer, see Start, Stop and Reset of the Timer above.
TIMER mode
* Settable range:
from 10 seconds up to 99 hours, 59 minutes and
59 seconds
* 0 seconds can be set for TIMER-2. In that case, TIMER-1 works
as an independent timer.
Press for more
than 2 seconds.
* If the watch is left untouched in the TIMER SETTING display with the digits
flashing, it will automatically return to the TIMER mode in 2 to 3 minutes.
TIMER-2 Operation

TIMER-2 starts countdown as soon as TIMER-1 has finished counting
down the set time.
 The time-up beeps for TIMER-1 and TIMER-2 sound differently.
 When 0 is set as the countdown time of TIMER-2, - - - is shown.
When the set time is upWhen the set time is up
TIMER2
Start
When the set time is up
TIMER2TIMER1
When the set time is up
TIMER1
󱂈
Timer setting procedure
TIMER-1 setting
Seconds → Minute → Hour Seconds → Minute → Hour
TIMER-2 setting
Number of repetitions
Button “D”
Button “E”
: Resetting timer
Button “B”: Mode change
Button “A”
: Start/stop
Button “C”: Lighting up backlight
Number of repetitions
TIMER mark
TIMER2
TIMER1
󰽨󰽨
󰽨󰽨 󰽨󰽨
󰽨
󰽥
󱂉