User Manual

Initial Set-up

The following guides you step by step through the initial Set-up of

the navigation system.

Firstly, remove the foil for protecting the device during transpor-

tation from the display.

I. Charging the battery

Attention

It can be necessary to recharge the battery for some

time initially before it is possible to run through the ini-

tial installation, according to the state of charging of

the battery installed.

Please pay attention to the following notes when handling the

battery:

• The charging status display will shine red until the naviga-

tion system is charged. Do not interrupt the charging proc-

ess before the battery is fully charged. This may take a few

hours. The navigation system is fully charged if the charging

display lights green.

• You can use the navigation system during the charging

process, but the power supply must not be interrupted dur-

ing initial set-up.

• Leave the external power supply connected to the naviga-

tion system for around 24 hours, so that the backup bat-

tery also charges-up fully.

• You can leave the external power supply connected, and

this is very handy for continuous operation. However, the

mains adapter also requires power even when it is not

charging up the battery of the navigation system.

• It can take several minutes until the device is ready to op-

erate again, following the connection of the external power

supply, if the charging state of the battery is very low.

• The battery will even be charged while the device is

switched off completely.