User Manual

English

V. Starting the Navigation Software

Note

Your memory card will always have to be inserted into

the device during the use of the navigation system, if

the card contains (additional) mapping material.

It will be necessary to carry out a reset to restart the

navigation system if the memory card has been re-

moved, only for a short time, while the system was

being used (see page 24). This Reset will take place

automatically, according to the navigation system.

1. Switch on your navigation system.

2. The Navigation software will start automatically or after tap-

ping on the navigation control button on the main screen,

according to the version.

3. Tap on Navigation on the screen for entering the destina-

tion and enter the address of your navigation destination.

Confirm your entry by clicking the

9 symbol to start the

navigation. You will receive the route information on the

screen, augmented by language statements, after a short

time, if the satellite reception is adequate.

Further information regarding the navigation software can be

found in the comprehensive manual on your navigation

CD(s)/DVD(s). This is a pdf-file you can read and print with the

any Acrobat Reader.

Note

The GPS-receiver will require some minutes for initiali-

zation when deployed for the first time. Even when

GPS signal reception is indicated the navigation could

be imprecise. In all future instances it will take about

30-60 seconds until a correct GPS-signal is available,

sufficient “sight” of the satellite is a prerequisite.