User Manual

Appendix

Mounting on (Bicycle) Handlebars

You can attach your navigation system to a bicycle as an

optional additional feature. A special holder is needed to do this.

The installation is explained in the following.

(similar picture)

1. Release both the screws connecting the clamp to the hold-

ing plate with the hexagon key.

2. Remove the rubber ring and wind it

around the handlebars.

3. Position the clamp on your bicycle

handlebars, by pulling it across the

handlebars from below.

4. Put the holding plate back onto the clamp and retighten

both the screws.

5. Seat the holder for the navigation system on the holder

plate until it locks into place audibly. Please pay attention

to the fact that the holder must only be seated in one di-

rection.

6. Now place the device on the holder. You must pay attention

to firm positioning.

Note

Your navigation system could also be equipped with a

different bicycle mounting, where the attachment of

mountings can vary slightly, according to the version.

Holding plate

Hexagon key

Screws

Clamp