Wireless CF Card WLF3020 User Guide Version 2.0 Jan.
Wireless CF Card_WLF3020 Design Specification Rev.6 A. Specifications Host Interfaces Co mp ac t F las h Compatible Interfaces Co mp ac t F las h Type Ι Form factor Co mp ac t F las h Type Ι Chipset MARVELL 88W8385 + 88W8015 Operation Voltage DC 3.3V Network Standards IEEE 802.11g/b Modulation Techniques DBPSK, DQPSK, CCK, 16QAM, 64QAM, Modulation Technology DSSS and OFDM Data Rate 802.11b: 11, 5.5, 2, 1 Mbps 802.
B. Marvell WLAN 802.11b/g CF8385PN Software Feature Short preamble 802.11b, 802.11g, and g/b mix-mode infrastructure 802.11b and 802.11g Adhoc mode C o re Fe atu re s Transmit fragmentation and receive defragmentation Client IEEE Power Save Infrastructure & Adhoc mode Basic rate adaptation - 11g/b for optimizing each STA throughput Background scan 64/ 128-bit WEP Encryption and open/ shared authentication WPA PSK WPA 802.1x Security WPAII PSK** WPAII 802.
C. Block Diagram ***Subject to be changed without notice.
Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
This device is intended only for OEM integrators under the following conditions: The transmitter module may not be co-located with any other transmitter or antenna. As long as conduction above is met, further transmitter test will not be required. However, the OEM integrator is still responsible for testing their end-product for any additional compliance requirements required with this module installed (for example, digital device emissions, PC peripheral requirements, etc.).
