Quick Start Guide

6 CDR8010 – Quick Start Guide
Activation and Battery Charge
NOTES

Make sure that SD card is inserted into the CDR8011. If the SD card is not inserted, you cannot activate
the CDR8011.
 Always use the attached car charger to activate and charge the CDR8011.
To activate and charge the CDR8011:
1. Plug one end of the charger into device’s USB Type C-Port.
2. Plug the other end of the charger into the cigarette lighter socket of your vehicle.
3. When the vehicle’s engine starts, the CDR8011 turns on and the built-in battery begins to charge.
When the ignition key is turned off and the vehicle’s engine stops, the CDR8011 goes to “Sleep” mode
3 seconds later. Note that while in “Sleep” mode, the CDR8011 consumes battery power.
Manual Power Off
To turn CDR8010 off manually:
1. Press the “Power Off” button and Hold for 3 seconds. The “Power off” confirmation dialog box
displays on touch screen.
2. On the confirmation dialog box, touch:
 Touch “Power off” to turn off the device.
 Touch other areas on the display to cancel.