Dear Customer, Thank you for choosing this quality product from ASKO. We hope it will meet your expectations and fulfill your needs for many years to come. Scandinavian design combines clean lines, everyday functionality, and high quality. These are key characteristics of all our products and the reason they are greatly appreciated throughout the world. To get the most out of your new dishwasher, we recommend that you read the operating instructions before using it.
Contents Front panel Important safety instructions Before washing for the first time Loading the dishwasher Using the dishwasher Settings 2 3 4 5 7 10 Care and maintenance instructions Troubleshooting Technical information Service Program chart 12 14 17 18 19 Front panel 1 2 3 4 5 6 7 8 9 10 1 On/Left-on mode 5 Rinse aid indicator 9 Delayed start 2 Program selector 6 Child lock (button lock) 10 Start/Stop 3 Program symbol 7 High temperature 4 Display 8 Long dry The panel is
Important safety instructions SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE WARNING! When using your dishwasher, follow basic precautions, including the following: • Read all instructions before using the dishwasher. • Use the dishwasher only for its intended function. • Use only detergents or wetting agents recommended for use in a dishwasher and keep them out of the reach of children.
Before washing for the first time Water supply Setting the rinse aid dosage The machine can be connected to either a hot (max. 160 °F, 70 °C) or cold water supply. We recommend a cold water supply. The water pressure should be 4.2-140 psi. See also the section Economic dishwashing in the chapter Loading the dishwasher. The section Settings describes how to set rinse aid amount. The rinse aid amount can be set from (Off) to (High dose).
Loading the dishwasher Economic dishwashing Typical load for 10 place settings Run programs only with a full load Wait until the dishwasher is fully loaded before running a program, this way you save energy. Use the Rinse & Hold program to rinse the dishes if there are any unpleasant odors while you wait for the dishwasher to become fully loaded. Run programs at a lower temperature If the dishes are only lightly soiled, you can select a lower temperature with certain programs.
Top cutlery tray The top cutlery tray accommodates cutlery, ladles, whisks, and other utensils. Lower basket Place plates, side plates, serving dishes, pots, and cutlery (in the cutlery basket) in the lower basket. Place pots and pans in the right rear of the lower basket for the best cleaning results from the two rear spray nozzles (Power Zone™ Pot & Pans), which are intended for these types of dishes. Raising the top cutlery tray 1 Remove the top cutlery tray.
Using the dishwasher Add detergent WARNING! Knives and other pointed items must be placed with the points down in the cutlery basket or horizontally in other baskets. Fold-down section for small items The cutlery basket has a fold-down section in the middle for small items, or small shafts, such as electric whisk attachments. a b c 1 Prewash detergent compartment 2 Main wash detergent compartment NOTE! Check that the spray arms can rotate freely.
WARNING! Children must be supervised – dishwasher detergent is corrosive! Hyg Hygiene This program is recommended for baby bottles and cutting boards when additional sanitation is required. The temperature is high in the main and final rinse. NOTE! Use only dishwasher detergent! Liquid hand-washing detergent must not be used as the foam that forms prevents the dishwasher from operating effectively. Delicate If the dishes are only lightly soiled, you can select Delicate.
You can vary the temperature as shown below: Sanitation: 150 °F (65 °C) / 160 °F (70 °C) Normal: 124 °F (51 °C) / 150 °F (65 °C) Heavy: 140 °F (60 °C)/150 °F (65 °C) Quick: 85 °F (30 °C) / 140 °F (60 °C) Delicate: 105 °F (40 °C) / 120 °F (50 °C) Eco: 130 °F (55 °C) / 140 °F (60 °C) Upper half: 130 °F (55 °C) / 150 °F (65 °C) Lower half: 130 °F (55 °C) / 150 °F (65 °C) Time remaining Once you have selected a program and options, the display indicates how long the program took the last time it wa
Settings Do as follows to open the settings menu: + 1. First, open the door. Turn off the dishwasher using the On/Left-on mode button (press and hold). Release the button. 2. Press and hold the On/Left-on mode button until the display lights up. 3. Within five seconds, press and hold the Program selector and the Long dry button. 4. Release the buttons when the display shows . TIP! Be sure to press right on the symbols, so as not to inadvertently activate any other button.
Button press Options (Off) Settings Description Operation volume This sound is used to confirm each button press. (Low) (High) Press Start/Stop to save the setting value and continue to the next setting. LCD contrast (Display on the front of the door) For adjusting the contrast of the display on the front door. Press Start/Stop to save the setting value and continue to the next setting. (Low) LCD contrast (Display on the panel) For adjusting the contrast of the display on the panel.
Care and maintenance instructions Coarse filter NOTE! The coarse filter traps larger food particles, which cannot get past the drain pump. Empty the coarse filter as necessary. The dishwasher must not be used without the filters in place! 1 Lift the coarse filter by the handle. Dishwashing results may be affected if the coarse filter is incorrectly fitted. 2 Empty the coarse filter. Remember to replace it! Drain pump Coarse filter The pump can be accessed from inside the dishwasher.
Door When cleaning the edge around the door, use only a slightly damp cloth (with a little cleaner if necessary). WARNING! Do not use a spray bottle or the like around the door lock. This is to ensure that water does not penetrate the door catch and come into contact with the electrical components. Lower spray arm • Pull the lower spray arm straight up to release it. Upper spray arm • The upper basket must be removed before the upper spray arm can be released.
Troubleshooting Display Type of fault Action Overfilling Call the Customer Care Center. Water outlet fault See "Water remains in the dishwasher above the filters" in the table below. Water inlet fault Check that the water supply valve is on. Inlet valve leakage Turn off the water supply valve and call the Customer Care Center. Turn off the machine with the On/Left-on mode button and then turn it on again to clear the error message from the display.
Problem Possible causes Action The dishwasher does not start. The Start/Stop start button has been pressed Press and hold Start/Stop until the display for too short a time. shows (the door open symbol). This indicates that the dishwasher is ready to start. The door is not properly closed. Check. A fuse/circuit breaker has been tripped. Check. The plug is not plugged into the power outlet. Check. The water supply valve is turned off. Check. Overflow/leaks. Check.
Problem Possible causes The touch buttons do not react when pressed. You have pressed the touch buttons too soon Wait a moment then try again. after opening the door. Dirt on the touch buttons. Action Clean with a dry or slightly damp cloth. Open the door until the display illuminates or If this symbol appears on the display, close the door and wait 30 seconds. Then open the door. the door is not open enough. Child lock (button lock) activated. 16 See the section Settings.
Technical information Technical data Height: 34-3/8" - 36-1/2" (873-927 mm) Width: 24" (610 mm) Depth: 22-7/8" (581 mm) Weight: 110 lb (50 kg) 1) Water pressure: 4.2–140 psi Electrical connection: See serial number tag and rating plate. Rated power: 1) See serial number tag and rating plate. Weight can vary due to different specifications.
Service Limited Warranty – Residential Appliances ASKO Distribution North America, LLC. (“ASKO”) warrants to the original purchaser (the “ASKO Customer”) of the ASKO product (the “ASKO Product”), who purchased the ASKO Product from a distributor, dealer, manufacturer’s representative or other seller who has been authorized by ASKO, that this ASKO Product is free of defects in materials and/or workmanship, subject to the terms and conditions set forth herein.
1 Lower half Connection to hot water, approx. 120 °F (50 °C). The energy label performance figures are based on this program. 0.01 0.6 0.6 0.5 0.5 0.9 0.1 0.7 0.4 0.9 4) 0:06 2:05 2:05 2:15 1:35 0:50 0:20 2:10 2:00 3:00 Energy (approx. kWh) Connection to cold water, approx. 50 °F (10 °C). (A cold water supply is recommended.) 0.01 1.2 1.2 0.8 0.9 1.5 0.2 1.3 0.8 1.5 Energy Dishwashing (approx. kWh) time (approx.
Quick guide Load the baskets 1. (See page 5.) Do not rinse dishes under running water before loading them in the dishwasher. Simply scrape off large food particles before loading the dishwasher. Check that the spray arms can rotate freely 2. Check also that the water supply valve is on. Add detergent 3. 4. The detergent compartment has a small compartment for prewash and a large compartment for the main wash. (See page 7.