Technical data

Page 12
Customer Care Center
1-800-898-1879
www.askousa.com
Now that all the connections are made and the machine
is in place under the cabinet, you should make the final
height adjustment.
1. You should set the rear
foot first. To do this, use a
screwdriver to rotate the
adjusting screw on the
bottom front of the machine.
Turn the screw clockwise to
raise the foot and counter clockwise to lower it.
2. Using a 5/8” (16 mm) wrench, adjust the locking nuts
until the machine is level. (The machine may have an
inclination of 3/16” (5mm) maximum without affecting
its performance.)
3. When the feet are properly adjusted, tighten the
locking nuts to the base pan.
SETTING THE TOE KICK DEPTH
1. Press the grey catches towards each other to release
the toe kick brackets.
2. Pull out the toe kick brackets as far as the installation
requires to provide the proper toe kick depth.
3. Once the toe kick brackets are at the appropriate depth,
press the grey catches away from each other to lock
the toe kick brackets in place.
4. The back side of the toe kick has hooks that will hang
the toe kick on the toe kick brackets. Lift the toe kick
up and let the hooks slide onto the brackets as you
lower the toe kick to the floor.
INSTALLING THE TOE KICK
FASTENING THE DISHWASHER TO THE CABINET
NOTE
When it is not possible to attach the dishwasher to the
cabinet, you should install tip guards. (See “Tip Guards”
on page 2.):
ADJUSTING THE LEVELING LEGS
NOTE:
If you want to mount a wooden door or a custom panel.
Do this before fastening the dishwasher to the cabinet!
See chapter “Fitting custom door panel”
It’s necessary to fasten the dishwasher to the cabinet so
it won’t tilt when the door is opened or if something heavy
is placed on the door. Use only the stainless steel screws
provided with the machine.
1. Use option A for U.S. or European
standard installations. Use option
B only for European standard
installations, or U.S. installations
where there is a hard counter-top
such as tile or marble.
2. Cover the screw heads with the plastic plugs provided
with the machine.
3. When the machine is properly attached, check
that the feet are tight against the floor and that the
machine is level.
NOTE:
Be sure to use white spacers to keep from over-tightening
the mounting screws.