OPERATING INSTRUCTIONS EN Dishwasher DBI653IB
Contents Front panel Safety instructions Before washing for the first time Loading the dishwasher Using the dishwasher Settings Care and cleaning 2 3 4 5 8 12 14 Troubleshooting Technical information Installation ASKO Service Information for test institute Your notes Quick guide 16 19 20 24 24 25 28 Dear Customer, Thank you for choosing this quality product from ASKO. We hope it will meet your expectations and fulfil your needs for many years to come.
Safety instructions NOTE! • Read the operating instructions and keep them in a safe place! • Number of place settings: 15 • Never use the dishwasher for any purpose other than that specified in these operating instructions. • Do not load the dishwasher door or dishwasher baskets with anything other than dishes. • Never leave the dishwasher door open as someone may trip on it.
Before washing for the first time 1. Checking water hardness 2. Basic settings Contact the local water utility to check the water hardness in your area. This is important with regard to how much detergent and rinse aid to use. To switch on the dishwasher, press and hold the main power switch until the display lights up. "Welcome to your new ASKO. This is a first time set up." is shown on the display. It is important that you choose the right settings to ensure good dishwashing results.
Loading the dishwasher 3. Top up with rinse aid Greener dishwashing By using rinse aid you will improve your drying result. You will also achieve a better dishwashing result with glassware and dishes. Do not rinse under running water Simply scrape off large food particles before loading the dishwasher. Press to open Choose a green detergent Read the environmental declaration on the packaging! Run programs only with a full load Wait to run a program until the dishwasher is full.
Fragile dishes The dishwasher's baskets Some cookware is not dishwasher safe. This can be for several reasons. Some materials cannot withstand strong heat, others can be damaged by dishwashing detergent. The dishwasher is equipped with a top cutlery tray, an upper basket and a lower basket with a cutlery basket. Exercise caution with, for example, handmade items, fragile decoration, crystal/glassware, silver, copper, tin, aluminium, wood and plastic. Look for the "Dishwasher safe" marking.
WARNING! Knives and other pointed items must be placed with the points down in the cutlery basket or horizontally in other baskets. Fold-down section for small items The cutlery basket has a fold-down section in the middle for small items, or small shafts, such as electric whisk attachments. Lower basket Place plates, side plates, serving dishes, pots and cutlery (in the cutlery basket) in the lower basket.
Using the dishwasher of the detergent to the prewash compartment. Contact the detergent manufacturer if you have questions about the detergent. Add detergent Press to open NOTE! Use only dishwasher detergent! Washing up liquid must not be used as the foam that forms prevents the dishwasher from operating effectively. Dishwasher tablets Halve the tablet if it is difficult to close the dispenser lid.
Press and hold the main power switch until the display lights up. Starting the dishwasher START Eco STOP 2:00 Speed mode Select the program Select a program mode The main power switch Press and hold the main power switch until the display turns on. Also check that the water tap is on. Select a program To select a program, press the Navigation button or until the desired program is shown on the display. Select a programme to suit the type of dishes and how dirty they are.
Intensive mode Improves the dishwashing results, but the dishwasher uses more energy and water. The program time is extended. Select an Option To select an option, press the option button until the desired option is shown on the display. The available options vary between programs. Extra Dry A higher temperature in the final rinse and a longer drying cycle improve the drying results if you activate this option. Energy consumption is slightly increased.
25 25 25 25 25 ECO wash 4) Heavy wash Auto wash Sanitation wash Time program 20 20 20 Quick Pro wash Upper half wash Lower half wash Connection to hot water, approx. 60 °C. The energy label performance figures are based on this program which is recommended for normally soiled load (no options). 4) 1.0 1.0 0.9 0.8 1.4 Connection to cold water, approx. 20 °C. 2:10 2:10 0:30 + 0:20 1:40 1:10 3) 60 °C 60 °C 55 °C 50 °C 70 °C 1.1 0.01 0.5-1.6 1.2 0.9-1.5 1.2 0.
Settings Open the dishwasher's Settings menu To open the dishwasher's Settings menu, press the Navigation button using the mode selector . or until Settings menu is shown on the display and confirm your selection To exit the dishwasher's Settings menu, select Exit and confirm your selection using the mode selector . Navigation buttons for choosing setting Mode selector to confirm current setting START 1� Language Settings English STOP Current setting Settings Options 1.
Settings Options 8. On/Off Super rinse Super rinse adds two extra rinses. Activated in the following programs: Heavy wash ECO wash Sanitation wash Plastic wash Lower half wash Upper half wash 9. High temperature On/Off Activate the setting High temperature to improve the dishwashing results. Energy consumption is slightly increased.
Care and cleaning Coarse filter The coarse filter traps larger food particles, which cannot get past the drainage pump. Empty the coarse filter as necessary. Top spray arm • The upper basket must be removed before the top spray arm can be released. See section Upper spray arm. • Pull out the top cutlery tray. Press the top spray arm up and unscrew the spray arm bearings counter-clockwise to remove the spray arm. Upper spray arm • The upper basket must be removed before the upper spray arm can be released.
4 In order to inspect the drainage pump, remove the coloured stop on the right in the bottom drain. Unblocking the inlet hose filter 5 Turn the pump wheel located behind the drainage pump stop by hand. Carefully remove any items. If the water supply contains small particles, the outer filter on the inlet hose may become blocked, which results in Water inlet fault. 6 Replace the drainage pump stop along with the fine and coarse filters.
Troubleshooting Type of fault on the display Action F10 Overfilling water 1 Clear the drainage pump. See the chapter Care and cleaning. If the problem persists, call the service department. F11 Water outlet fault See “Water remains in the dishwasher” in the table “Problem” below. If the problem persists, call the service department.
Problem Possible causes Action The dishes are not clean. The spray arms do not rotate. Check that the dishes are not blocking the spray arms. Spray arm holes or bearings blocked. Clean the spray arms. See Chapter Care and cleaning. Unsuitable dishwashing program. Choose a longer programme. Incorrect detergent dosage. Dose according to water hardness. Far too much or far too little detergent results in poorer dishwashing results. Old detergent. Detergent is a perishable product.
Problem Possible causes Action Water remains in the dishwasher. The filters are blocked. Clean the coarse and fine filters. The filters are not fitted correctly. Check that the filter handle is locked in the stop position. The handle should point towards the back of the dishwasher. Debris in the drainage pump. Clean the drainage pump. See the chapter Care and cleaning. Kink in drainage hose. Check that the hose is free from kinks and sharp bends. Blocked drainage hose.
Technical information Information on energy labelling Energy labelling Australian standard: AS/NZS 2007 Number of place settings: 15 Dishwashing programs: ECO wash 1) , no options Program time: 2:50 hours:minutes Connection: Cold water 20 °C Test method for noise measurement: IEC 60704-2-3 1) This dishwashing program is the standard cleaning cycle used to compile the energy labelling information.
Installation [mm] 1198 596 131-186 700 819*- 872 714 559 50 30-94 *Remove locking nuts for an installed height of 820-821 mm. Nominal dimensions. Actual measurements may vary. Safety instructions Transport protection for the door • Connections to electricity, water and drainage must be performed by a qualified professional. Do not forget to remove the transport protection for the door when unpacking the dishwasher. • Always follow applicable regulations for water, drainage and electricity.
B. Freestanding A freestanding dishwasher must be fitted with anti-tip brackets. This comprises two brackets, which are screwed into place as illustrated. Adjust the height and slide the dishwasher into place The dishwasher is then pushed in so that the brackets engage the rear feet. Now the dishwasher will not topple if pressure is put on the open door. If the dishwasher is installed completely on its own, side panels and a worktop must both be fitted.
Drainage connection This dishwasher is suitable for installing in a raised recess (to attain an ergonomic working height). This means that the dishwasher can be placed so that the drainage hose runs to a lower level than the bottom of the dishwasher, such as by routing it directly to a floor drain. The dishwasher is fitted with an integrated anti-siphon device to prevent the machine from being emptied of water during the wash cycle. min.
Screwing the dishwasher into place Dishwasher kick panel (Applicable only to built-in dishwashers.) The dishwasher is supplied with a kick panel. 2x After fastening the machine, check that the front feet still touch the floor.
ASKO Service Information for test institute Information about your product Request test institute information via e-mail dishwashers@appliancedevelopment.com. There is a QR code on the compliance plate. Scan the code to view information about your product. The request should include the details on the product’s serial number plate. Include the article number (1) and the serial number (2). Contact the service department Read the chapter Troubleshooting before contacting the service department.
Your notes 25
Your notes 26
Your notes 27
Quick guide Load the baskets (See page 5.) 1. Do not rinse dishes under running water before loading them in the dishwasher. Simply scrape off large food particles before loading the dishwasher. Check that the spray arms can rotate freely Check also that the water tap is on. 2. Don't forget! Empty the coarse filter and clean the fine filter when necessary. (See page 14.) Add detergent The detergent compartment has one smaller compartment for the prewash and one for the main wash. (See page 8.) 3.