Use & Care Guide
Table Of Contents
- Front page
- Contents
- Your dishwasher
- Important safety instructions
- Before washing for the first time
- Greener dishwashing
- Loading the dishwasher
- Using the dishwasher
- Add detergent
- The main power switch
- Select program
- Select program mode
- Select option
- Starting the dishwasher
- Time remaining
- Status light™
- Stopping or changing a program
- If you want to load more dishes
- If the dishwasher is turned off due to a power failure
- Once the program has finished
- How to get the best drying results
- Unloading the dishwasher
- Program chart
- Settings
- Care and maintenance instructions
- Troubleshooting
- Installation instructions
- Service
- Technical information
ActionPossible causesProblem
Press and hold Start/Stop until
the display shows "Program
started, close door in 4 sec".
The Start/Stop start button has
been pressed for too short a
time.
The dishwasher does not start.
Close the door within four sec-
onds, otherwise the dishwasher
will not start.
The door is not closed properly
or was not closed immediately
after pressing the Start/Stop
button.
If you want the dishwashing
program to continue, press
Start/Stop and close the door
within four seconds.
You have opened the dishwash-
er to add more dishes while a
program is in progress.
Check.A fuse/circuit breaker has been
tripped.
Check.The plug is not plugged into the
power outlet.
Check.The water supply valve is turned
off.
Check.Overflow/leaks.
Turn off the water supply valve.
Pull out the plug and call the
Customer Care Center.
A whirring sound (the drain
pump) is heard from the dish-
washer and does not stop when
the main power switch is turned
off.
Press and hold Start/Stop for
three seconds if you want to
cancel the Delayed Start option.
Check that the Delayed Start
option has not been selected.
Table continued from last page
31
Troubleshooting