Use & Care Guide
Table Of Contents
- Front page
- Contents
- Your dishwasher
- Important safety instructions
- Before washing for the first time
- Greener dishwashing
- Loading the dishwasher
- Using the dishwasher
- Add detergent
- The main power switch
- Select program
- Select program mode
- Select option
- Starting the dishwasher
- Time remaining
- Status light™
- Stopping or changing a program
- If you want to load more dishes
- If the dishwasher is turned off due to a power failure
- Once the program has finished
- How to get the best drying results
- Unloading the dishwasher
- Program chart
- Settings
- Care and maintenance instructions
- Troubleshooting
- Installation instructions
- Service
- Technical information
Transport protection for the door
Do not forget to remove the transport protection for the door when unpacking the dishwasher.
Trim kit
The dishwasher is equipped with a trim kit to fit the 24'' cutout standard. If a European width of 23
5/8'' (600 mm) is required, remove the trim kit.
Adjust the trim kit
The trim kit can be adjusted backward to level the dishwasher tub.
Placing the dishwasher
The dishwasher is intended to be built in under a countertop. The built-in measurements are shown
in the illustration. Make sure that the cord and hose hole's edges are even and will not damage the
drain and inlet hoses or the power cord.
['']
The electrical and
water supplies
should enter
through the area
indicated by the
shading on the
illustration.
* 33 7/8'':
Remove the trim kit.
37
Installation instructions