Use & care guide

10
Custumer Care Center
1-800-898-1879
www.askousa.com
7
1
2
A lighted red field by the button indicates
that the Wrinkle free option has been acti-
vated.
Delayed Start
Select or deselect this option by pressing
the Delayed Start button. The machine will
start the program 5 hours after you select
this option + the Start/Stop button.
A lighted red field by the button indicates
that the option has been activated. If you
change your mind, press the Start/Stop but-
ton for three seconds. You can now start the
machine as usual.
Press the Start button
Drying time remaining
An estimate of the remaining drying time will
be shown in the display within 2 minutes of
the drying program starting. For example,
1:35 means that approximately 1 hour and
35 minutes remain until the load achieves
the selected level of dryness. If the Wrinkle
free option has been selected, the drum will
rotate every minute for 2 hours after cooling.
If you want to stop or change a program
Press and hold the Start/Stop button for
3 seconds. The red field next to the button
goes out.
Note!
The program is not affected if the program
selector is changed after the program starts.
To load or remove laundry
If you want to load or remove washing once
you have started the machine, open the
door and the machine will stop automati-
cally. Load more laundry, close the door and
press the Start/Stop button.
6
Drying program finished
The text in the display indicates
that the program has finished
If the Wrinkle free option has been
selected, the drum will rotate every
minute for 2 hours after cooling.
Important!
• Clean the lint filter after each load.
Caution!
If the lint filter becomes clogged, the ma
-
chine’s automatic overheating cut-off may
be triggered. To enable the machine to be
restarted, the filter must be cleaned and
the machine allowed to cool for around
30 minutes.
Cleaning the lint filter
1. Grasp the filter handle and pull it towards
you.
2. Pull the filter out of its holder.
3. Open the filter and remove the lint by
hand scraping the back and front of both
panels.
4. Fold the filter up and re-insert it into its
holder. The filter may need to be cleaned
if limescale deposits occur, see the “Care
and cleaning” chapter.