Operating instructions

Page 7
ENGLISH ENGLISH
CLEANING THE PIN TRAPCLEANING THE PIN TRAP
Your washing machine has a pin trap designed to trap
pins, hairpins, coins and similar items. This trap should
be cleaned occasionally. To do this, follow the steps
below:
1. Make sure as much water as possible is drained
out of the tub then turn off the power to the machine.
2. Using the flat edge of the
liquid detergent partition
piece, a flathead screwdriver
or similar item, gently pry open
the drain pump cover, as
illustrated.
4. Pull the small black
drain hose loose from
its position on the door
cover and let the water
drain into the pan.
7. Replace the drain cover and return the drain hose to
its position on the door.
5. Unscrew the pin trap cover and lift it out.
3. There is always a small amount of water in the drain
pump area. Before you open the drain cover, place a
shallow container, such as a pie pan, on the floor
below the drain to catch the water.
REMOREMOVING VING AN OBJECT FRAN OBJECT FROMOM
BETWEEN BETWEEN THE DRTHE DRUM UM ANDAND
OUTER CONTOUTER CONTAINERAINER
Occasionally, a small item may fall between the drum
and the outer container. Such items should be removed
because they could corrode and cause rust stains on
the laundry. To remove the item, follow the instructions
below:
CARE CARE AND CLEANING INSTRAND CLEANING INSTRUCTIONSUCTIONS
CLEANING THE DETERGENTCLEANING THE DETERGENT
DRAWERDRAWER
CLEANING CLEANING THE CONTRTHE CONTROL POL PANELANEL
To clean the control panel, use only a warm, damp rag.
To prevent penetration of water into the door lock and
electrical components, never use a spray of any kind.
Also, never use abrasive cleaners or scouring pads on
the outer surfaces because they will scratch the finish
and they could remove the writing on the control panel.
Some paper towels may also scratch the finish.
1. Pull the drawer out as far
as it goes then lift it up and
pull it out completely, as
illustrated.
2. Clean the drawer with a
soft brush under warm
running water. Do not put
the drawer in a dishwasher.
3. Replace the drawer by
tilting it into position.
6. You can now clean out any
grit or small objects. You
should also clean the
pump rotor at the back of
the pump housing.
2. Grip the paddle with your other
hand and pull it toward you.
1. Insert a flathead screwdriver
in the center hole in the
paddle and carefully push it
to the left.
4. Replace the paddle in its fixing hole with the F-mark
toward you. Check that the paddle clips are properly
located in the slots and slide the paddle toward the
back as far as it will go.
3. Lift up the paddle and remove the object.
REMOREMOVING HARD VING HARD WWAATERTER
STSTAINS FRAINS FROM OM THE DRTHE DRUMUM
If you live in an area with hard water, the washer drum
may become coated with a grey-white deposit. To
remove it, pour about an ounce of citric acid in the drum
and run a Normal wash program at 205° F.
Never spray clean the control panel. You could damage
the electrical components. Also, never use abrasive
cleaners, scouring pads or paper towels on the outer
surfaces because they will scratch the finish and they
could remove the writing on the control panel.
WARNING!