User's Manual
Table Of Contents
- Important Safety Instructions
- Welcome to Hydrasynth!
- Quick Start Guide
- Overview
- Hydrasynth Desktop
- Understanding the Modules
- The Oscillator Group
- The Mixer Module
- The Filters and their Controls
- The Amp Module
- The Envelopes
- The LFOs
- The Effects
- The Voice Module
- Ribbon Controller (keyboard only)
- The Arpeggiator Section
- Mastering the Macros
- The Mod Matrix
- The CV / Gate Section
- Patch Management
- The System Setup Pages
- Control Combinations
- Scales
- Hydrasynth Specifications
- Declaration of Conformity
68
Additional Arp Features
Latch and Sustain
Press [LATCH] to activate Latch mode. This
enables you to take your ngers o the keys or
pads and use both hands to adjust parameters
while an arpeggio is running.
Use [SHIFT] + [LATCH] to activate Sustain
mode. This works whether an arpeggio is
running or not. It’s the same response as using
a sustain pedal.
Between these two parameters there are four
potential combinations, as shown below. The
lighting of the [LATCH] button LED provides a
visual clue as to which settings are active.
Latch Sustain [LATCH] LED status
On O Button lit constantly
On On Flashing cycle: 0.8s lit, 0.2s
unlit
O On Flashing cycle: 0.5s lit, 0.5s
unlit
O O Button dimly lit
Initialize the Arp
Hold [SHIFT] and press the [ON] button
to initialize the Arpeggiator module. All
parameters will return to their defaults.