User's Manual
Table Of Contents
- Important Safety Instructions
- Welcome to Hydrasynth!
- Quick Start Guide
- Overview
- Hydrasynth Desktop
- Understanding the Modules
- The Oscillator Group
- The Mixer Module
- The Filters and their Controls
- The Amp Module
- The Envelopes
- The LFOs
- The Effects
- The Voice Module
- Ribbon Controller (keyboard only)
- The Arpeggiator Section
- Mastering the Macros
- The Mod Matrix
- The CV / Gate Section
- Patch Management
- The System Setup Pages
- Control Combinations
- Scales
- Hydrasynth Specifications
- Declaration of Conformity
84
The System Setup Pages
Operational Notes
Navigation
The System Setup pages work the same way
all other modules do, but here are some
reminders:
• To access the next or previous page, use
the Page Down / Up arrows.
• Cycle forward to the desired page quickly
by pressing [SYSTEM SETUP] repeatedly.
• Use [SHIFT] + the Page Down / Up arrows
to jump to the last page or back to rst
page.
Access, Action
• Some elds have Control buttons that
execute a function, such as the Factory
Reset. These are indicated by the word
(action) in the charts.
• Some pages have access buttons that open
a Calibration page. These are indicated by
the word (access) in the charts . Follow the
instructions in the Left display to calibrate
the selected item.
Saving the Settings
Press [EXIT] or any module button to save
System Setup changes. The message “System
saving...” will be shown in the Left display for
about 1 second. Note that sound output is
silenced while the settings are being saved.
Notes About Notes
Some parameters are self-explanatory, but
others have additional information below the
chart.
Master: Page 1
Control knob Function Range Description
1 Transpose - / +11 semitones Transpose keys, pads chromatically
2 Tuning 380 to 500 Hz Sets center tuning frequency
3 O’Scope On, O Toggles waveform animation in
Left display
4 Memory protect On, O Prevents overwriting of patches
5 Left contrast 0 to 127 Sets contrast for Left display
6 Right contrast 0 to 127 Sets contrast for Right display
7 LED Dim On, O Toggles LED brightness between
50% and full
8 Light show O, 5-, 15-, 30
minutes
Sets timeout period for onset of
light show