User's Manual
Table Of Contents
- Important Safety Instructions
- Welcome to Hydrasynth!
- Quick Start Guide
- Overview
- Hydrasynth Desktop
- Understanding the Modules
- The Oscillator Group
- The Mixer Module
- The Filters and their Controls
- The Amp Module
- The Envelopes
- The LFOs
- The Effects
- The Voice Module
- Ribbon Controller (keyboard only)
- The Arpeggiator Section
- Mastering the Macros
- The Mod Matrix
- The CV / Gate Section
- Patch Management
- The System Setup Pages
- Control Combinations
- Scales
- Hydrasynth Specifications
- Declaration of Conformity
85
Master: Page 2
Control knob Function Settings Description
1 Knob Mode Absolute, Pickup,
Scale
How Direct knobs edit values when
moved
2 Knob Speed Slow, Medium,
Fast
Sets Control knob response speed
3 Tempo Lock On, O Selects Global tempo or per-patch tempo
4 Macro Button Toggle, Trigger,
Switch, Reset
Determines behavior of Macro Buttons
5 Safe Edit On, O Prevents accidental loss of edited patch
Knob Mode
This setting governs the response of the
Variable knobs (p. 16) in the Filter and
Arpeggiator sections, not the Selection knobs
(p. 16).
• Absolute: the parameter value jumps to
the physical position of the knob
• Pickup: the knob must pass through the
parameter value before an edit will happen
• Scale: parameter value edit begins from
the current knob position; the remaining
throw of the knob covers the remaining
range of the parameter. After the knob
reaches its minimum or maximum position
the parameter value range conforms to
the physical position of the knob (see
Absolute).
Knob Speed
This determines the response speed of the
Control knobs only. It also aects the ner
[SHIFT] + scroll movements. With a setting of
Slow a full turn is required to cover the full
parameter range; with a setting of Fast it takes
less than half a turn, which can also sacrice
parameter resolution.
Tempo Lock
Each patch stores its own Tempo setting.
Setting Tempo Lock to On enables the tempo
to remain the same while selecting patches.
Macro Button
These settings are described in the Macro
Button Response (p. 71) section of the
Mastering the Macros chapter.
Safe Edit
With this parameter set to On, if you try to
select another patch before saving an edited
patch, a message will ask for conrmation
rst. If a Macro control was the only thing
changed, the conrmation message will not
be displayed.
Note: This does not prevent Hydrasynth from
responding to MIDI program changes.