User's Manual

AsokaUSA PlugLAN
TM
3050 User’s Manual V1.01a
Asoka USA Corporation Tel: [phone]
2344-A Walsh Avenue Santa Clara, CA 95051 USA Fax: [phone]
URL: www.asokausa.com
2. Hardware Installation
2.1 Connect Device and PC
a. Connect 3050 to AC power with wires P1 (Phase1) and N (Neutral), please see
Figure 1.
b. Connect 3050 to a PC or Laptop with CAT5 cable through RJ45 port.
c. Set network configuration of PC to communicate with 3050. The default IP
address of 3050 is as below:
z Default LAN IP address: 192.168.1.250
d. Power on 3050, Use command “ping” in PC side to test the connection
between the Gateway and PC. For example, you connect PC to LAN port, the
IP address of PC should be set to “192.168.1.x” (1<x<255 and x!=253), the
network mask is “255.255.255.0”.
2.2 Set Device in AC Power Panel Box
a. Set the CTs: make the AC wires which we need monitor through CTs.
b. Set 3050 in the AC power panel box and Connect wires of CTs to 3050 as
Figure 2.
c. Connect 3050 and AC power with wires P1 (Phase1), P2 (Phase2), P3 (Phase3)
and N (Neutral) as Figure 2.
d. The device is powered on when LED power light, see Figure 1.
e. The PLC signal have been received when LED plc flash, see Figure 1.
Figure1. 3050 silkscreen