User's Manual

8 of 38
Advanced Configuration
(Expert Users Only)
This chapter provides information on installing and setting up the
PlugLink-ETH-500.
NOTE: Do not connect the PlugLink-ETH-500 into a power strip, extension cord,
un-interruptible power supply (UPS), or surge protector. This may prevent the unit from
working properly or degrade the network performance.
Installing the Software
Following are software installation procedures for advanced users.
NOTE: Software installation is not required for normal use. The utility is used to
change the security settings and view information about the network.
1. Insert the enclosed Installation Resource CD into your CD-ROM drive If the PlugLink-
ETH-500 Installation Utility does not appear within 30 seconds, select your CD-ROM
drive and double-click the Setup.exe icon to start the Installation Utility.
2. Select the language preference, and click the Run button.