Instruction Manual

TXASOBTHUM-FB Wireless LED Speaker & Humidifier
Instruction Manual (Read before proceeding)
FCC Statement:
Changes or modifications not expressly approved by the party responsible for compliance could void the
user's authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications.However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions
(1)this device may not cause harmful interference, and (2) this device must accept any interference
received,including interference that may cause undesired operation.
Power:
Humidifier:
Plug the small connector of the included USB power cable into the USB power port on the back of unit
Plug the large connector into a USB power port or into a compatible 5V USB adaptor (not included) and
plug into a wall socket.
The LED indicator will turn red when the speaker is connected to a power source.
Bluetooth Speaker:
The s peaker is powered by USB or built-in battery.
To charge the battery
Insert the small connector of the supplied micro-USB power cable into the USB power port on the back of
the speaker.
Insert the large connector into the USB port on a computer or a 5V USB adapter (not included) and plug
into a wall socket
The LED indicator will turn red when the speaker is connected to a power source.
Diagram:

Summary of content (2 pages)