Installation Guide

Cutting option
Deburring cut tiles
If desired, use a metal le to debur the cut edges.
If cutting tiles is necessary, use one of our recommended tools and methods listed
above. A snip is the recommended cutting method. Alternative cutting methods
include a wet saw or chop saw for any necessary straight cuts. Use a combination
of a snip and chisel for cutting notches out for various cutouts needed, such as an
electrical outlet.
Measure where the cut must be made and cut the tile. Take the cut tile to the work
space and place it in its intended location, ensuring it ts properly. Cut and install all
remaining tiles using the same steps described above. When tiles are installed to your
satisfaction, press each again rmly with your hand. This will ensure that the adhesive
bonds to the substrate.
Cutting Tiles
Cutting the inside edge with chisel
Starting a notch using a snip
Finished notch cutout
Cutting a straight cut with a snip
Do not le the edge at an angle
Proper position for squaring up an
edge or smoothing a rough spot
Wet tile saw can be a cutting option
for straight cuts