Owner`s manual

Page 13

CR24 MOUNTAINEER LOG SET

(WITH DOUBLE BURNER DX24MV LOG BASE)

WARNING: POSITIONING OF LOGS IS VERY CRITICAL. (See Figures 6a & 6b)

LOG PLACEMENT FOR CR24 MOUNTAINEER LOG SETS:

1) Align the hole on back of the rear log (#1) with the right rear leg and slide down to the supports. Left side

of rear log (#1) will simply rest on left support.

2) Place the middle log (#2) on the support between the front and rear burner sliding log flush to the back of

the support. Center from side to side.

3) Next place front log (#3) behind the front of the andirons, resting on top of its legs. Small notch on the

right of the log (#3) should line up with the right andiron support.

4) Left top log (#4) has two holes provided to fit over the pins in the left side of the rear log (#1) and the left

side middle log (#2) to ensure proper fit.

5) Center top log (#5) has a hole to fit over the pin in the center of the rear log (#1). The other end of the

center top log (#5) comes to rest on the flattened area in the center of the middle log (#2).

6) Right top log (#6) has a hole to fit over the pin on the right side of the middle log (#2). The other end of

the right top log (#6) comes to rest on the top right of the front log (#3) pointing towards the andiron.

Completed Log Placement (Front View)

Completed Log Placement (Left Angle View)

Figure 6b.

Figure 6a.