Material Safety Data Sheets

CHANGING ORIFICES

(continued)

4. Remove the screws securing the control panel to the front of the grill. Carefully tilt down the

control panel being careful not to damage the wires to the switches and LED light bar. Pull off

the connectors to the 2 switches and the LED light bar at this time. Remove the control panel

from the grill and set aside.

3. When replacing the elbow and orifice assembly back into the burner bracket, it is important to

maintain the original spacing shown below for proper burner performance. Consult the table on

page 7 for identification of orifices. The size is also stamped on the orifice.

.25” (6.3 mm)