Operating instructions

１８
Powerin
g
on the unit Initial Setu
p
Procedure
Only after all connections are complete, connect the power
cord and power on the unit.
plug the standard jack end into a wall socket or power
strip.
Press STANDBY on the remote control or front panel
to bring the system out of standby mode. The
system is now ready to use.
There are 3 power states for this unit:
1. OFF – not connect the power cord. The unit draws no
power and cannot be turned on by the remote control.
2. STANDBY - the unit has not been taken out of standby by
pressing either the STANDBY key on the remote control
or the STANDBY button on the front panel. The unit
draws a slight amount of power to enable the remote
control receiving circuit.
3. ON - the STANDBY button on the remote control or the
STANDBY button on the front panel has been pressed.
The unit is ready to use.
Using the Menus
When the unit is first powered on, you'll be prompted to set
the time and date as well as TV Tuner options. You can
always change any of the settings you choose during the
Initial Setup later in the DVD Recorder's SETUP MENU.
Use the UP/DOWN keys to increase or decrease the
value of a selected field or move to a field above or
below. Use the LEFT/RIGHT keys to move to the
previous or next fields.
Press ENTER to select an option and/or continue.
Time and Date
Setting the Time and Date correctly is important, as the Timer
recordings depend on an accurate setting. The Time format used is
24HR. This means that 1:00PM will be represented as 13:00,
2:00PM as 14:00, and so on. Use the UP/DOWN keys to increase
or decrease the Time or Date and the LEFT/RIGHT keys to move
to a different field. When you're done, move to DONE and press
ENTER.
Watch TV
Play/Edit Disc
Record program
Setup menu
Channel source
Channel setup
Press SETUP to exit
Recording setup
DVD control
General
Video
Speaker
Audio
Press SETUP to exit
Recording Quality
Auto chapter
Set clock
Select a field then use to edit
Press SETUP to exit
Hour Mi nute Year Mouth Da
y
23 11 2003 DEC
31
The Initial Setup is now complete. Remember, any settings
chosen during the Initial Setup can be changed at any time in
the DVD Recorder's SETUP MENU. Press SETUP to exit the
Initial Setup and begin using your DVD Recorder.
Notes on “Power” states
DVD RECORDER OPERATION
1
2
1
2