User Guide

2727

ASRock 4Core1333-Viiv Motherboard

EnglishEnglish

English

2.9 Onboard Headers and Connectors2.9 Onboard Headers and Connectors

2.9 Onboard Headers and Connectors

Onboard headers and connectors are NOT jumpers. Do NOT place

jumper caps over these headers and connectors. Placing jumper caps

over the headers and connectors will cause permanent damage of the

motherboard!

FDD connector

(33-pin FLOPPY1)

(see p.2 No. 30)

Note: Make sure the red-striped side of the cable is plugged into Pin1 side of the

connector.

Primary IDE connector (Blue)

(39-pin IDE1, see p.2 No. 10)

Note: Please refer to the instruction of your IDE device vendor for the details.

Serial ATAII Connectors These six Serial ATAII (SATAII)

(SATAII_1 (Port0): see p.2, No. 16) connectors support SATA data

(SATAII_2 (Port1): see p.2, No. 17) cables for internal storage

(SATAII_3 (Port2): see p.2, No. 19) devices. The current SATAII

(SATAII_4 (Port3): see p.2, No. 21) interface allows up to 3.0 Gb/s

(SATAII_5 (Port4): see p.2, No. 15) data transfer rate.

(SATAII_6 (Port5): see p.2, No. 22)

SATAII_6 (Port5) connector can be used for internal storage device or

be connected to eSATAII connector to support eSATAII device. Please

read “eSATAII Interface Introduction” on page 34 for details about eSATAII

and eSATAII installation procedures.

connect the black end

to the IDE devices

connect the blue end

to the motherboard

SATAII_1 (Port0)

SATAII_2 (Port1)

SATAII_5 (Port4)

SATAII_6 (Port5)

SATAII_3 (Port2)

SATAII_4 (Port3)

the red-striped side to Pin1

80-conductor ATA 66/100/133 cable