User manual

4848
4848
48
3.3.23.3.2
3.3.23.3.2
3.3.2
Chipset ConfigurationChipset Configuration
Chipset ConfigurationChipset Configuration
Chipset Configuration
Memory Remap Feature
Use this item to enable or disable memory remap feature. Configuration
options: [Enabled] and [Disabled]. The default value is [Disabled].
DRAM Frequency
If [Auto] is selected, the motherboard will detect the memory module(s)
inserted and assigns appropriate frequency automatically. You may select
[333MHz (DDR2 667)], [400MHz (DDR2 800)] or [533MHz (DDR2 1066)] for
DDR2 memory modules, or select [400MHz (DDR3 800)], [533MHz (DDR3
1066)] or [667MHz (DDR3 1333)] for DDR3 memory modules. The configura-
tion options depend on the CPU and memory module you adopt on this
motherboard. Please refer to page 8 for the CPU FSB frequency and its corre-
sponding memory support frequency.
Flexibility Option
The default value of this option is [Disabled]. It will allow better tolerance for
memory compatibility when it is set to [Enabled].
DRAM CAS# Latency
Use this item to adjust the means of memory accessing. Configuration
options for DDR2 memory modules are [3], [4], [5], [6] and [Auto].
Configuration options for DDR3 memory modules are are [5], [6], [7], [8],
[9] and [Auto].
DRAM RAS# to CAS# Delay
This controls the latency between the DRAM active command and the
read / write command. Configuration options: [Auto], [3 DRAM Clocks], [4
DRAM Clocks], [5 DRAM Clocks] and [6 DRAM Clocks].
DRAM RAS# Precharge
This controls the idle clocks after a precharge command is issued.
Configuration options: [Auto], [3 DRAM Clocks], [4 DRAM Clocks],
[5 DRAM Clocks] and [6 DRAM Clocks].
BIOS SETUP UTILITY
v02.54 (C) Copyright 1985-2005, American Megatrends, Inc.
Chipset Configuration
Memory Remap Feature
DRAM Frequency
Flexibility Option
DRAM CAS# Latency
DRAM RAS# to CAS# Delay
DRAM RAS# Precharge
DRAM RAS# Activate to Precha
[Auto]
[Disabled]
[Auto]
[Auto]
[Auto]
[Auto]
[Disabled]
Select Screen
Select Item
+ - Change Option
F1 General Help
F10 Save and Exit
ESC Exit
F9 Load Defaults
ENABLE: Allow
remapping of
overlapped PCI memory
above the total
physical memory.
DISABLE: Do not allow
remapping of memory.
Advanced
Primary Graphics Adapter
[PCI]
OnBoard HD Audio
Front Panel
OnBoard Lan
[Auto]
[Auto]
[Enabled]
CPU Voltage
DRAM Voltage
NB Core Voltage
[Auto]
[Auto]
[Auto]