Specifications

SuperDVR & WS 401 Series Cards

Connect J2 to PC serial port and you may use alarm board by

SuperDVR system.

Connect Audio Signal

For WS 401, connect the audio input device to the microphone

connector on the motherboard.

Note:

Before installing the Video Capture Card hardware in PCI port of

the motherboard, make sure you’ve installed Microsoft DirectX

9.0. Then turn on the computer, the system will remind you to

“Found new hardware”.

Notice:

Just click “cancel” and ignore the pop-up message.

Insert the CD that contains WS series capture card driver into the

CD tray, and run Setup.exe program to install the driver. The

default installation path is ‘C:\Program Files\SuperDVR’.

Notice: In case it warns that ‘Can’t find card’ when running the

SuperDVR software, please restart the computer.

Install Video Capture Card Driver

Run Setup.exe, and the installation interface appears as below: