User Guide

2424
2424
24
Chipset Configuration:
AGP Aperture Size: It refers to a section of the PCI memory address range
used for graphics memory. We recommend that you leave this field at the
default value unless your AGP card requires other sizes.
ICH Delayed Transaction: Select [Enabled] will enable delayed transactions
for internal register, FWH, and LPC interface accesses.
USB Controller: Use this to enable or disable the use of USB controller.
USB Device Legacy Support: Use this to enable or disable support to emulate
legacy I/O devices such as mouse, keyboard,... etc.
CPU Thermal Throttling: Select [Enabled] will enable P4 thermal control
circuit to keep CPU from overheated.
DRAM Write Throttling: Select [Enabled] will enable north bridge thermal
management to keep it from overheated.
SDRAM CAS Latency: This parameter controls the latency between the read
command and the time the data available.
Configure SDRAM Timing by SPD: Select [Enabled] will configure the follow-
ing 3 items by the contents in the SPD (Serial Presence Detect) device.
SDRAM RAS# Precharge: This controls the idle clocks after a precharge
command is issued.
SDRAM RAS# to CAS# Delay: This controls the latency between the
SDRAM active command and the read / write command.
SDRAM Precharge Delay: This controls the number of DRAM clocks for
RAS minimum.
AMIBIOS SETUP UTILITY - VERSION 3.31a
Advanced
AGP Aperture Size
ICH Delayed Transaction
USB Controller
USB Device Legacy Support
CPU Thermal Throttling
DRAM Write Throttling
******** DRAM Timing ********
SDRAM CAS Latency
Configure SDRAM Timing by SPD
SDRAM RAS# Precharge
SDRAM RAS# to CAS# Delay
SDRAM Precharge Delay
[ Setup Help ]
F1:Help
Esc:Previous Menu
F9:Setup Defaults
F10:Save & Exit
+/-:Change Values
Enter:Select
Sub-Menu
:Select Item
Chipset Configuration
Disabled
Enabled
Disabled
Enabled
Enabled
Auto
Disabled
3 Clocks
3 Clocks
7 Clocks
<Enter> to select the
size of mapped memory
for graphics data.
64MB