Owner's Manual

36
BIOS SETUP UTILITY
Memory Timing
Select Screen
Select Item
+- Change Option
F1 General Help
F9 Load Defaults
F10 Save and Exit
ESC Exit
v02.54 (C) Copyright 1985-2003, Amer ican Megatrends, Inc.
OC Tweaker
Select Screen
Select Item
+- Change Option
F1 General Help
F9 Load Defaults
F10 Save and Exit
ESC Exit
Bank Interleaving
Channel Interl eaving
[Auto]
[Auto]
Power Down Enable
[Enabled]
CAS Latency (CL)
TRCD
TRP
TRAS
Command Rate
[Auto]
[Auto]
[Auto]
[Auto]
[Auto]
TRC
TWR
TRFC
TRRD
TWTR
TRTP
[Auto]
[Auto]
[Auto]
[Auto]
[Auto]
[Auto]
Power Down Enable
Use this item to enable or disable DDR power down mode.
Bank Interleaving
Interleaving allows memory accesses to be spread out over banks on the
same node, or accross nodes, decreasing access contention.
Channel Interleaving
It allows you to enable Channel Memory Interleaving. The default value for
DDR2 is [Hash 1]. The default value for DDR3 is [Hash 2].
CAS Latency (CL)
Use this item to adjust the means of memory accessing. The default value
is [Auto].
TRCD
Use this to adjust TRCD values. The default value is [Auto].
TRP
Use this to adjust TRP values. The default value is [Auto].
TRAS
Use this to adjust TRAS values. The default value is [Auto].
Command Rate
Use this item to change Command Rate Auto/Manual setting. Min: 1N.
Max: 2N. The default is [Auto].
You can set one of the standard values as listed for DDR3 memory mod-
ules: [400MHz DDR3_800], [533MHz DDR3_1066], [667MHz DDR3_1333]
and [800MHz DDR3_1600].
DRAM Voltage
Use this to select DRAM voltage. The default value is [Auto].
Memory Timing