Specifications

ManualsBrandsASROCK ManualsMotherboardsA330GC

1414

2.4 Expansion Slot (PCIE Slot)2.4 Expansion Slot (PCIE Slot)

2.4 Expansion Slot (PCIE Slot)

There is One PCIE slot on this motherboard.

PCIE slot: PCIE slot is used for PCI Express cards with x 1 lane width cards, such as

Gigabit LAN card, SATA2 card, etc.

Installing an expansion cardInstalling an expansion card

Installing an expansion card

Step 1. Before installing the expansion card, please make sure the power supply is

switched off or the power cord is unplugged. Please read the documenta-

tion of the expansion card and make adjustments to hardware settings for

the card before you start the installation.

Step 2. Remove the bracket facing the slot that you intend to use. Keep the screws

for later use.

Step 3. Align the card connector with the slot and press firmly until the card is com-

pletely seated on the slot.

Step 4. Fasten the card to the chassis with screws.

2.5 Jumpers Setup 2.5 Jumpers Setup

2.5 Jumpers Setup

The illustrations show how jumpers are

setup. When the jumper cap is placed on

pins, the jumper is “Short”. When no jumper

cap is placed on pins, the jumper is “Open”.

The illustrations show a 3-pin jumper, whose

pin1 and pin2 are “Short” when jumper cap is

placed on top.

Jumper Setting Description

PS2_USB_PWR1 Short pin2, pin3 to enable

(see p.9/10 No. 14) +5VSB (standby) for PS/2

or USB wake up events.

Note: To select +5VSB, it requires 2 Amp and higher standby current provided by

power supply.

Clear CMOS

(CLRCMOS1, 2-pin jumper)

(see p.9/10 No. 1)

+5VSB

2_3

2-pin jumper

Watchdog Function Jumpter Short pin1-2 to enable

(see p.9/10 No. 15) watchdog, short pin 2-3 to

disable watchdog.

Note: CLRCMOS1 allows you to clear the data in CMOS. The data in CMOS includes

system setup information such as system password, date, time, and system

setup parameters. To clear and reset the system parameters to default setup,

please turn off the computer and unplug the power cord from the power supply.

After waiting for 15 seconds, use a jumper cap to short 2 pins on CLRCMOS1

for 5 seconds.

+5V

1_2