Owner's Manual

52
For EP2C606-4L/D16 / EP2C602-4L/D16 / EP2C602/D16:
In single VGA card mode, it is recommended to install a PCI
Express x16 graphics card on PCIE2 or PCIE4 slot.
For EP2C606-4L / EP2C602-4L / EP2C602:
In single VGA card mode, it is recommended to install a PCI
Express x16 graphics card on PCIE3 or PCIE5 slot.
Installing an expansion card
Step 1. Before installing an expansion card, please make sure that the
power supply is switched off or the power cord is unplugged.
Please read the documentation of the expansion card and make
necessary hardware settings for the card before you start the
installation.
Step 2. Remove the system unit cover (if your motherboard is already
installed in a chassis).
Step 3. Remove the bracket facing the slot that you intend to use. Keep
the screws for later use.
Step 4. Align the card connector with the slot and press rmly until the
card is completely seated on the slot.
Step 5. Fasten the card to the chassis with screws.
Step 6. Replace the system cover.