User manual

21
English
FM2A58M+ BTC
2.6 Onboard Headers and Connectors
Onboard headers and connectors are NOT jumpers. Do NOT place
jumper caps over these headers and connectors. Placing jumper caps
over the headers and connectors will cause permanent damage of the
motherboard!
USB 2.0 Headers Besides six default USB 2.0
(9-pin USB45)
ports on the I/O panel, there
(see p.11 No. 17)
are two USB 2.0 headers on
(9-pin USB67)
this motherboard. Each USB 2.0
(see p.11 No. 18)
header can support two USB
2.0 ports.
Serial ATA2 Connectors These six Serial ATA2
(SATA_1: see p.11, No. 15)
(SATA2) connectors support
(SATA_2: see p.11, No. 16)
SATA data cables for internal
(SATA_3: see p.11, No. 14)
storage devices. The current
(SATA_4: see p.11, No. 13)
SATA2 interface allows up to
(SATA_5: see p.11, No. 12)
3.0 Gb/s data transfer rate.
(SATA_6: see p.11, No. 11)
DUMMY
GND
GND
P+
P-
USB_PWR
P+
P-
USB_PWR
1
SATA_2 SATA_4 SATA_6
SATA_1 SATA_3 SATA_5
Front Panel Audio Header This is an interface for the front
(9-pin HD_AUDIO1)
panel audio cable that allows
(see p.11 No. 21)
convenient connection and
control of audio devices.
J_SENSE
OUT2_L
1
MIC_RET
PRESENCE#
GND
OUT2_R
MIC2_R
MIC2_L
OUT_RET
1. High Denition Audio supports Jack Sensing, but the panel wire on
the chassis must support HDA to function correctly. Please follow the
instruction in our manual and chassis manual to install your system.
2. If you use AC’97 audio panel, please install it to the front panel audio
header as below:
A. Connect Mic_IN (MIC) to MIC2_L.
B. Connect Audio_R (RIN) to OUT2_R and Audio_L (LIN) to OUT2_L.
C. Connect Ground (GND) to Ground (GND).
D. MIC_RET and OUT_RET are for HD audio panel only. You don’t
need to connect them for AC’97 audio panel.