User Manual
Table Of Contents
- Chapter 1 Introduction
- 1.1 Package Contents
- Chapter 2 Installation
- 2.1 Installing the CPU
- 2.2 Installing the CPU Fan and Heatsink
- 2.3 Installing Memory Modules (DIMM)
- 2.4 Expansion Slots (PCI Express Slots)
- 2.5 Jumpers Setup
- 2.6 Onboard Headers and Connectors
- 2.7 Dr. Debug
- 2.8 SLITM and Quad SLITM Operation Guide
- 2.9 CrossFireXTM and Quad CrossFireXTM Operation Guide
- 2.10 M.2_SSD (NGFF) Module Installation Guide
- Chapter 3 Software and Utilities Operation
- Chapter 4 UEFI SETUP UTILITY
English
34
2.8 SLI
TM
and Quad SLI
TM
Operation Guide
is motherboard supports NVIDIA
®
SLI
TM
and Quad SLI
TM
(Scalable Link
Interface) technology that allows you to install up to two identical PCI Express x16
graphics cards.
2.8.1 Installing Two SLI
TM
-Ready Graphics Cards
Step 1
Insert one graphics card into PCIE2 slot
and the other graphics card to PCIE3 slot.
Make sure that the cards are properly
seated on the slots.
Step 2
If required, connect the auxiliary power
source to the PCI Express graphics cards.
Requirements
1. You should only use identical SLI
TM
-ready graphics cards that are NVIDIA
®
certied.
2. Make sure that your graphics card driver supports NVIDIA
®
SLI
TM
technology. Download
the drivers from the NVIDIA
®
website: www.nvidia.com
3. Make sure that your power supply unit (PSU) can provide at least the minimum power
your system requires. It is recommended to use a NVIDIA
®
certied PSU. Please refer to
the NVIDIA
®
website for details.